Zumokuta Clan wrote:
For Marine animals, it's best to not use the nest, so just put the marine animals "without" nests.
No, just use the nests, otherwise the marine animals swim across the whole water and even attack your harbour, if you build one. Render the nests invisible by disselecting 'Visible' and enlarge the ActionAreas (the regions in which the animals walk, their 'territory') at Trigger/Regions
. Hold Ctrl and drag the arrow that shows to the sky.
The reason you should use nests, it's because, for example:
You put an Allosaurus somewhere far away (or just nearby your base), that Allosaurus can actually go in or in front of your base, since it doesn't have a nest. It's recommended to use nests.
Exactly, that's the reason. Otherwise you would probably be killed by a hungry allosaur before you have more than 10 workers. ^^
For mountains use the "Alt" button, change the brush, (where it says "Default Q 10x10"), to anything higher than 10 or you can customize it. To lower the scape, use the "Smooth" button (Blur), and the Rough button, well, to rough the terrain (Noise). To make water use the "Plateau" button. If you don't change the brush anything higher than "10x10", then you cannot make mountains, except for Plateau, you don't need the brush for it.
No, lowering the scape can be achieved by right-clicking on the terrain, at the function ALT. Smooth is good to decrease the height distances of two terrains with different heights.
And for mountains, you can randomly set 10x10 Blocks with different heights across one place and then smooth the whole thing with a bigger brush. Rough the mountain a bit, then smooth it again and the mountain is finished.